Were committed to dealing with such abuse according to the laws in your country of residence.When you submit a report, well investigate it and take the appropriate action.Well get back to you only if we require additional details or have more information to share.
Samsung Clp 310 Full Names AreNote that email addresses and full names are not considered private information.
If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive. Dropouts If faded areas, generally rounded, occur randomly on the page: A single sheet of paper may be defective. The moisture content of the paper is uneven or the paper has mo ist spots on its surface. The manufactu ring processes can cause some areas to reject toner. Go to printer properties, click Paper tab, and set type to Thick Pa per. If these steps do not correct the problem, contact a service representa tive. White Spot s White spots appear on the page: The paper is too rough and a lot of dirt from the paper falls to the inner devices with in the machine, which mean s the transfer belt may be dirty. Vertical lines If black vertical streaks appear on the page: The imaging unit ha s probably been scratched. See page 42. If white vertical streaks appear on the page: The surface of the LSU part inside the machine may be dirty. Clean the LSU by opening and closing the front cover several times and if the problem still occurs cal l the contact a service representative. CONDITION SUGGESTED SOLUTIONS Aa Bb Cc Aa Bb Cc Aa Bb Cc Aa Bb Cc Aa Bb Cc AaBbCc AaBbCc AaBbCc AaBbCc AaBbCc Color or Black background If the amount of background shading becomes unacceptable: Change to a lighter weight paper. See page 31. Check the machines en vironment: very dry (low humidity) or high humidity (hig her than 80 RH) conditions can i ncrease the amount of background shading. Samsung Clp 310 Install A NewSee page 31. Remove the toner cartridge and install a new one. See page 41. Vertical repetitive defects If marks repeatedly appear on the printed side of the page at even intervals: The toner cartridge may be damaged. After the printout, if you still have the same problems, remove the toner cartridge and install a new one. If the defects occur on the back of the page, the problem wil l likely correct itself after a few more pages. Background scatter Background scatter results from bits of toner randomly distributed on the printed page. Do not open packages of paper until necessary so that the paper does not absorb too much moisture. If background scatter occurs on an envelope, change the printing layo ut to avoid printing over a reas that have overlapping seams on the reverse side. Printing on seams can cause problems. Samsung Clp 310 Software Application OrIf background scatter covers the entire surface area of a pr inted page, adjust the print resolution through your software application or the p rinter properties.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |